Graduate Theses & Dissertations

effects of environmental variables and dissolved organic matter characteristics on the diffusion coefficient of dissolved organic matter using diffusive gradients in thin films
The efficacy of the diffusive gradients in thin films (DGT) passive samplers to provide accurate measurements of free metal ions and those complexed with dissolved organic matter (DOM) was investigated. DOM controls the diffusive properties of DOM-complexed metal species in natural systems. Knowing the diffusion coeiffiecent (D) for DOM of different molecular weights (MW) and the major environmental variables influencing D is critical in developing the use of DGT passive samplers and understanding labile species. D and MW were determined for natural and standard DOM. No noticeable changes in DOM MW were observed during the diffusion process, suggesting that DOM remains intact following diffusion across the diffusive gel. Data analysis revealed that MW had the greatest influence on D, with a negative relationship between D and MW, except in tidal areas where ionic strength influence on D was significant. This study provides further characterization of the variables influencing D using the DGT technique. Author Keywords: Diffusion coefficient, Diffusive gradients in thin films, Dissolved organic matter, Flow field-flow fractionation, Principal Component Analysis, UV-Vis Spectroscopy
Using Fluorescent Carbon Dots for Biosensing Applications of Amino Acids
Amino acids make up proteins, which are the building blocks of life. A balance of amino acids is needed to maintain a healthy state. Tyrosine (Tyr) is synthesized from the metabolism of phenylalanine, which is an essential amino acid, meaning it can only be obtained from the diet. It is related to many metabolic and neurodegenerative diseases. Tyr can undergo post-translational modifications such as phosphorylation and nitration, which are implicated in cancer and nitrative stress, respectively. Although there are many methods to detect Tyr and its analogues, phosphotyrosine (pTyr) and nitrotyrosine (nTyr), these methods are time-consuming, involve expensive instruments and involve tedious process. This research proposes a new type of nanomaterials, carbon dots (CDs), to detect these amnio acids. Data indicate that CDs can be used to detect nTyr with a limit of detection of 34 μM in the linear range of 20 - 105 μM. The amenability of CD-nTyr assay was also tested in various biological matrices and biological molecules and was shown to be sensitive to nTyr. Nitration of Tyr was carried out in the presence of sodium nitrite and hydrogen peroxide catalyzed by either Cu(II) or Fe(III) to mimic biological reactions and CDs were tested as both inhibitors and indicators of Tyr nitration. Although CDs did not inhibit the nitration reaction of Tyr, they did not serve as indicators of Tyr nitration due to the quenching of CDs by the nitrating agents. This shows the importance of using CDs to detect nTyr and further use it for biological applications to detect diseased states. Author Keywords: amino acids, carbon dots, nanomaterials, sensor, spectroscopy, tyrosine
Speciation of Aluminum and Zinc in Three Streams of a Forested Catchment of the Boreal Zone
This study presents a detailed assessment of the chemical speciation of aluminum and zinc in three streams of a small, acid-sensitive forested catchment on the southern edge of the Precambrian Shield. Speciation analysis was achieved using an in-situ analytical technique known as Diffusive Gradient in Thin film (DGT) which measures labile metals, and a predictive computer algorithm (WHAM VI) which calculates metal species concentrations. Three types of DGT with different metal scavenging capabilities were used and a total of 11 deployments performed across four seasons. WHAM VI predictions showed that the organic fraction of aluminum was the main contributor to the dissolved concentrations in the main inflow stream (PC1) (~ 80 %) and the lake's outflow (PCO) (~ 75%); in the upland stream (PC1-08) the inorganic fraction contributed ~ 75%. For zinc the free ion was the single most important contributor to the dissolved concentration (< 90%) in all three streams. A comparative study of the DGT and WHAM methods showed an agreement between their inorganic concentrations during the spring season. Both methods indicate the greatest environmental impact for Al takes place during snow melt period in PCO and PC1-08 and in the summer for PC1. The greatest environmental impact for Zn predicted with WHAM VI, occurs during the spring in all three streams. Author Keywords: Aluminum, DGT, Metal speciation, WHAM, Zinc
SARS-CoV-2 Protein-based Detection Using Localized Surface Plasmon Resonance
During the COVID-19 pandemic, nucleic acid and antibody-based testing methods were heavily relied upon, but can be costly, time-consuming and exhibit high false -negative and -positive rates. Thus, alternative strategies are needed. Viral antigens such as the SARS-CoV-2 spike (S) glycoprotein are critical in the function of the virus and useful as diagnostic biomarkers for viral infections. For biosensing applications, aptamers are suitable high-affinity and cost-effective binding partners for their specific targets. Using localized surface plasmon resonance (LSPR), real-time, rapid acquisition of results can be achieved, essential for improving the efficacy of a sensor. Herein, LSPR aptamer sensors were fabricated for the detection of the SARS-CoV-2 protein. Data indicate that the best performing aptasensor was the streptavidin-biotin sensor, while the current gold aptasensor exhibited lower sensitivity and the fabrication of the carboxyl aptasensor was unsuccessful. The S1 aptamer selectively bound the S1 protein with high binding affinity. Excellent shelf-life stability, reusability, and high recovery in complex matrices was also maintained. Additionally, a receptor binding domain (RBD) functionalized sensor was fabricated to examine the interactions with angiotensin converting enzyme 2 (ACE2), for future assessment of inhibitors used in drug therapies. Overall, LSPR has been demonstrated as a viable tool for measuring SARS-CoV-2 related aptamer-protein and protein-protein interactions, and this strategy may be applied to other viral or non-viral antigen targets. Author Keywords: Antigen-based Detection, Coronavirus, COVID-19, Inhibition, Localized Surface Plasmon Resonance, SARS-CoV-2
Purification and Identification of Selenium-containing C-phycocyanin from Spirulina
Selenium is an essential trace nutrient to many organisms, yet in high concentrations it is toxic. Organic selenium is more bioavailable to aquatic biota than inorganic selenium, but is usually found in much lower concentrations. Algae are known to biotransform inorganic selenium into several organo-selenium compounds, but it is unknown whether any of these bioaccumulate in the food chain. In this study, selenium was incorporated into the methionine residues of an algal photosynthetic protein, c-phycocyanin from Spirulina spp. The extent of selenium incorporation was quantified by inductively coupled plasma-mass spectrometry (ICP-MS), and the protein was identified using electrospray mass spectrometry (ES-MS). C-phycocyanin was isolated and purified from Spirulina with a final recovery of 20-30 % of the total c-phycocyanin present. Selenomethionine replaced 92.8% ± 1.22 of the methionine residues in c-phycocyanin when grown in 2.5 ppm sodium selenite. ES-MS was used to obtain protein spectra, and pure c-phycocyanin was identified. Data of full scans provided estimated masses of both protein subunits--α-chain measured at 18,036 Da; β-chain measured at 19,250 Da--close to the theoretical masses. Protein fragmentation by collision-induced dissociation and electron capture dissociation provided approximately 52 % amino acid sequence match with c-phycocyanin from Spirulina platensis. This study demonstrates the incorporation of selenium into an algal protein, and the identification of c-phycocyanin using electrospray ionization-mass spectrometry. Author Keywords:
Novel Silica Sol-Gel Passive Sampler for Mercury Monitoring in Aqueous Systems
A novel passive sampler for mercury monitoring was prepared using organosilica sol-gel materials. It comprises a binding layer with thiol groups for mercury complexation and a porous diffusive layer through which mercury can diffuse and arrive at the binding layer. Our study demonstrated that this new sampler follows the principle of passive sampling. The mass of mercury accumulated in the binding layer depends linearly on the mercury concentration in solution, the sampling rate and the exposure time. A typical sol-gel sampler is characterized by a diffusive layer of 1.2 &mum, in which mercury ions diffuse with a coefficient of D = 0.09~10-6 cm2/s. The capacity for mercury uptake is approximately 0.64 &mug/cm2. Mercury diffusion and binding in the passive sampler are independent of the type of mercury-chloride complex. Its sampling rate increases with increasing water turbulence and decreases with increasing DOM amount. The field trial of sol-gel sampler in Miller Creek shows the concentration gained from the sol-gel passive sampler is slightly lower than that from the spot sampling. Author Keywords:
Electrochemical versus Chemical Oxidation of Bulky Phenols
Phenolic compounds are used in industry, such as agriculture and biotechnology, and inevitably end up in our environment. These compounds may serve as a phenolic precursor to produce raw materials for a wide range of applications. Chemical oxidation has been the common synthetic pathway to oxidize phenols and related compounds. However, traditional chemical approaches suffer from use of harsh chemicals, waste generation, and lack of reaction selectivity. Electrochemical synthesis has emerged as an alternative method to mitigate common challenges associated with organic synthesis. Herein, electrochemical oxidation of 2,6-diphenylphenol (DPP) and 2,2-dihydroxybiphenol (DHBP) was carried out and compared to traditional chemical oxidation. Contrasted with chemical oxidation, cyclic voltammetry of DPP resulted in a range of products based on the specific potential ranges used, whereas chemical oxidation of DHBP yield a dark-coloured polymeric product. The electrooxidation and chemical oxidation of DPP and DHBP resulted in a solution colour change, indicative of the formation of new, but different products monitored by UV-vis, and characterized by nuclear magnetic spectroscopy (NMR), X-ray single crystal diffraction, IR spectroscopy, transmission electron microscopy (TEM), and gas chromatography-mass spectrometry (GC-MS). The data indicate that the synthetic outcomes are dependent on the synthetic methodology employed, and that electrooxidation and chemical oxidation can form products unique to the pathway utilized. Author Keywords: chemoselectivity, electrochemistry, phenols, radical, synthesis
Development and Use of Passive Samplers for Monitoring Dissolved and Nanoparticulate Silver in the Aquatic Environment
Silver nanoparticles (nAg) are the largest and fastest growing class of nanomaterials, and are a concern when released into aquatic environments even at low μg L-1+). Diffusive gradient in thin films (DGT) with a thiol-modified resin were used to detect labile silver and carbon nanotubes (CNT-sampler) were used to measure nAg. Laboratory uptake experiments in lake water provided an Ag+ DGT diffusion coefficient of 3.09 x 10 -7 cm2s-1 and CNT sampling rates of 24.73, 5.63, 7.31 mL day-1, for Ag+, citrate-nAg and PVP-nAg, respectively. The optimized passive samplers were deployed in mesocosms dosed with nAg. DGT samplers provided estimated Ag+ concentrations ranging from 0.15 to 0.98 μg L-1 and CNT-samplers provided nAg concentrations that closely matched measured concentrations in water filtered at 0.22 μm. Author Keywords: ICP-MS, mesocosms, nanoparticles, nanosilver, passive sampling
Analysis and reactions of aqueous selenide and other reduced inorganic selenium compounds under anoxic conditions
Selenide is cited as a geochemically important selenium (Se) species, but it is unknown whether selenide is a stable aqueous ion in natural waters. The feasibility of using anoxic anion exchange chromatography (AEC) coupled to dynamic reaction cell-inductively coupled plasma-mass spectrometry to separate aqueous selenide was investigated with the goal of quantifying this anion to determine its importance in reducing waters. It was possible to qualitatively identify selenide using AEC, but much of the aqueous selenide oxidises to Se0 faster than the separation procedure could be completed. AEC analyses of solutions containing polyselenides produced peaks for unidentified Se compounds, which have been assigned tentative structures Se2O22-, Se2O32-, and Se2O62- based on close matches in retention time to stable S compounds. The results of this work show that aqueous selenide can be qualitatively observed in synthetic solutions using AEC, but it is unknown whether these conditions are relevant to natural waters. Author Keywords: anoxic speciation, polyselenides, selenide, selenium geochemistry, selenium speciation, selenoselenate

Description

Graduate student theses produced at Trent University. You may also browse theses and dissertations by year, program, or author.

In collections

Search Our Digital Collections

Query

Enabled Filters

  • (-) ≠ Physiology
  • (-) = Environmental and Life Sciences
  • (-) = Master of Science
  • (-) = Analytical chemistry

Filter Results

Date

2004 - 2024
(decades)
Specify date range: Show
Format: 2024/05/01

Collection

Author Name

Name (Any)

Subject (Topic)