Graduate Theses & Dissertations

Paleolandscape Reconstruction of Burleigh Bay, Ontario 12,600 cal BP to Present
This thesis presents a palaeotopographic reconstruction of the Burleigh Bay region of Stony Lake (Kawartha Lakes Region, Ontario) from 12,600 cal BP to present. The paleotopographic reconstructions are used to model paleoshoreline locations and archaeological site potential for the Late Paleoindian and early Archaic periods. Isostatic rebound following the end of the last glacial period has altered the topography in the region and water levels are now artificially managed by dams constructed in the 1830s. I completed a high-resolution bathymetric survey using a kayak equiped with a GPS coupled single-beam sonar. Utilizing GIS technology and isostatic rebound response surface models, I created paleotopographic reconstructions for 12,600 cal BP, 11,500 cal BP, 7,000 cal BP, 5,700 cal BP, and present. Results show that water levels in Burleigh Bay have been regressing over time until dam construction. Early site potential is centered in northern inland areas. Site potential following 7,000 cal BP is concentrated in northern areas flooded by the dam. Based on the reconstructions, surveys in lacustrine granite shield regions that follow the Ontario Standards and Guidelines for Consultant Archaeologists risk missing areas of high archaeological potential for early sites in these environments. Paleolandscape reconstructions would alleviate this issue by modeling paleoshoreline changes over time. Author Keywords: Canadian Shield, Early Archaic, Isostatic Rebound, Kawartha Lakes, Late Paleoindian, Paleolandscape
wind tunnel based investigation of three-dimensional grain scale saltation and boundary-layer stress partitioning using Particle Tracking Velocimetry
Aeolian transport of sand particles is an important geomorphic process that occurs over a significant portion of the earth’s land surface. Wind tunnel simulations have been used for more than 75 years to advance the understanding of this process; however, there are still several principles that lack validation from direct sampling of the sand particles in flight. Neither the three-dimensional dispersion of, nor the momentum carried by particles in flight have been properly measured. This has resulted in the inability to validate numerical particle dispersion models and the key boundary-layer momentum partitioning model that serves as the framework for understanding the air-sand feedback loop. The primary impediment to these measurements being made is a lack of tools suited for the task. To this end, this PhD aims to improve existing particle tracking technology, thus enabling the collection of particle measurements during wind tunnel experiments that would address the aforementioned knowledge gaps. Through the design and implementation of the Expected Particle Area Searching method, a fully automated particle tracking velocimetry system was developed with the capability to measure within ½ grain diameter of the bed surface under steady state transport conditions. This tool was used to collect the first 3-D data set of particle trajectories, from which it was determined that a mere 1/8th of sand transport is stream aligned and 95% is contained within ± 45o of the mean wind direction. Particles travelling at increasing spanwise angles relative to the stream aligned flow were found to exhibit different impact and ejection velocities and angles. The decrease in the number of particles with increasing height in the saltation cloud, very close to the bed is observed to transition from a power to a linear relation, in contrast to previous literature that observed an exponential decay with coarser vertical resolution. The first direct measurements of particle-borne stress were captured over a range of wind velocities and were compared with earlier fluid stress measurements taken using Laser Doppler Anemometry. In support of established saltation theory, impacting particle momentum is found to contribute strongly to particle entrainment under equilibrium conditions. In opposition to established theory, however, particle-borne stress was found to reach a maximum above the surface and does not match the change in air-borne stress with increasing distance from the surface. Near surface splashed particles, measured herein for the first time, appear to play a greater role in stress partitioning than previously thought. This study suggests that research is needed to investigate the role of bed load transport on stress partitioning, to differentiate between airborne trajectory types, and to develop particle tracking tools for field conditions. Author Keywords: Aeolian Transport, Eolian Transport, Particle Tracking Velocimetry, Saltation, Stress Partitioning, Wind Tunnel Simulation
Aeolian Impact Ripples in Sand Beds of Varied Texture
A wind tunnel study was conducted to investigate aeolian impact ripples in sand beds of varied texture from coarsely skewed to bimodal. Experimental data is lacking for aeolian megaripples, particularly in considering the influence of wind speed on ripple morphometrics. Additionally, the modelling community requires experimental data for model validation and calibration. Eighteen combinations of wind speed and proportion of coarse mode particles by mass were analysed for both morphometrics and optical indices of spatial segregation. Wind tunnel conditions emulated those found at aeolian megaripple field sites, specifically a unimodal wind regime and particle transport mode segregation. Remote sensing style image classification was applied to investigate the spatial segregation of the two differently coloured size populations. Ripple morphometrics show strong dependency on wind speed. Conversely, morphometric indices are inversely correlated to the proportion of the distribution that was comprised of coarse mode particles. Spatial segregation is highly correlated to wind speed in a positive manner and negatively correlated to the proportion of the distribution that was comprised of coarse mode particles. Results reveal that the degree of spatial segregation within an impact ripple bedform can be higher than previously reported in the literature. Author Keywords: Aeolian, Impact Ripples, Megaripple, Self-organization, Wind Tunnel

Search Our Digital Collections

Query

Enabled Filters

  • (-) ≠ Farell
  • (-) ≠ Bell
  • (-) ≠ Native American studies
  • (-) ≠ Metcalfe
  • (-) = Geomorphology

Filter Results

Date

2004 - 2024
(decades)
Specify date range: Show
Format: 2024/03/28

Degree Discipline

Subject (Topic)