Graduate Theses & Dissertations

Novel Silica Sol-Gel Passive Sampler for Mercury Monitoring in Aqueous Systems
A novel passive sampler for mercury monitoring was prepared using organosilica sol-gel materials. It comprises a binding layer with thiol groups for mercury complexation and a porous diffusive layer through which mercury can diffuse and arrive at the binding layer. Our study demonstrated that this new sampler follows the principle of passive sampling. The mass of mercury accumulated in the binding layer depends linearly on the mercury concentration in solution, the sampling rate and the exposure time. A typical sol-gel sampler is characterized by a diffusive layer of 1.2 &mum, in which mercury ions diffuse with a coefficient of D = 0.09~10-6 cm2/s. The capacity for mercury uptake is approximately 0.64 &mug/cm2. Mercury diffusion and binding in the passive sampler are independent of the type of mercury-chloride complex. Its sampling rate increases with increasing water turbulence and decreases with increasing DOM amount. The field trial of sol-gel sampler in Miller Creek shows the concentration gained from the sol-gel passive sampler is slightly lower than that from the spot sampling. Author Keywords:
Speciation of Aluminum and Zinc in Three Streams of a Forested Catchment of the Boreal Zone
This study presents a detailed assessment of the chemical speciation of aluminum and zinc in three streams of a small, acid-sensitive forested catchment on the southern edge of the Precambrian Shield. Speciation analysis was achieved using an in-situ analytical technique known as Diffusive Gradient in Thin film (DGT) which measures labile metals, and a predictive computer algorithm (WHAM VI) which calculates metal species concentrations. Three types of DGT with different metal scavenging capabilities were used and a total of 11 deployments performed across four seasons. WHAM VI predictions showed that the organic fraction of aluminum was the main contributor to the dissolved concentrations in the main inflow stream (PC1) (~ 80 %) and the lake's outflow (PCO) (~ 75%); in the upland stream (PC1-08) the inorganic fraction contributed ~ 75%. For zinc the free ion was the single most important contributor to the dissolved concentration (< 90%) in all three streams. A comparative study of the DGT and WHAM methods showed an agreement between their inorganic concentrations during the spring season. Both methods indicate the greatest environmental impact for Al takes place during snow melt period in PCO and PC1-08 and in the summer for PC1. The greatest environmental impact for Zn predicted with WHAM VI, occurs during the spring in all three streams. Author Keywords: Aluminum, DGT, Metal speciation, WHAM, Zinc
Development and Use of Passive Samplers for Monitoring Dissolved and Nanoparticulate Silver in the Aquatic Environment
Silver nanoparticles (nAg) are the largest and fastest growing class of nanomaterials, and are a concern when released into aquatic environments even at low μg L-1+). Diffusive gradient in thin films (DGT) with a thiol-modified resin were used to detect labile silver and carbon nanotubes (CNT-sampler) were used to measure nAg. Laboratory uptake experiments in lake water provided an Ag+ DGT diffusion coefficient of 3.09 x 10 -7 cm2s-1 and CNT sampling rates of 24.73, 5.63, 7.31 mL day-1, for Ag+, citrate-nAg and PVP-nAg, respectively. The optimized passive samplers were deployed in mesocosms dosed with nAg. DGT samplers provided estimated Ag+ concentrations ranging from 0.15 to 0.98 μg L-1 and CNT-samplers provided nAg concentrations that closely matched measured concentrations in water filtered at 0.22 μm. Author Keywords: ICP-MS, mesocosms, nanoparticles, nanosilver, passive sampling
effects of environmental variables and dissolved organic matter characteristics on the diffusion coefficient of dissolved organic matter using diffusive gradients in thin films
The efficacy of the diffusive gradients in thin films (DGT) passive samplers to provide accurate measurements of free metal ions and those complexed with dissolved organic matter (DOM) was investigated. DOM controls the diffusive properties of DOM-complexed metal species in natural systems. Knowing the diffusion coeiffiecent (D) for DOM of different molecular weights (MW) and the major environmental variables influencing D is critical in developing the use of DGT passive samplers and understanding labile species. D and MW were determined for natural and standard DOM. No noticeable changes in DOM MW were observed during the diffusion process, suggesting that DOM remains intact following diffusion across the diffusive gel. Data analysis revealed that MW had the greatest influence on D, with a negative relationship between D and MW, except in tidal areas where ionic strength influence on D was significant. This study provides further characterization of the variables influencing D using the DGT technique. Author Keywords: Diffusion coefficient, Diffusive gradients in thin films, Dissolved organic matter, Flow field-flow fractionation, Principal Component Analysis, UV-Vis Spectroscopy

Search Our Digital Collections

Query

Enabled Filters

  • (-) ≠ Reid
  • (-) ≠ Doctor of Philosophy
  • (-) ≠ Business education
  • (-) = Environmental science
  • (-) ≠ Atmospheric sciences
  • (-) = Analytical chemistry

Filter Results

Date

2004 - 2024
(decades)
Specify date range: Show
Format: 2024/03/28

Degree

Degree Discipline

Subject (Topic)